VDEIJK ® 10m³ Portal Container

The model is made of PLA plastic with a slightly matte finish. Fine print lines are visible and can be sanded or primed for a smoother finish, if desired.

Color may vary by model. The surface is paintable and suitable for bonding.

Please note: slight imperfections are part of the 3D printing process and give each model a unique character.

This model is suitable for further finishing by the model builder.

To sand:

– Use fine sandpaper (grit 400–800) to smooth out any print lines or imperfections.

– Work carefully in small strokes, especially around details.

Primers and Paints:

– Apply a plastic primer for better adhesion (e.g. Tamiya or Vallejo).

– After drying, the model can be finished with acrylic paint or model varnish.

– Multiple thin layers give the best results.

Gluing:

– Use super glue (cyanoacrylate) for strong, fast adhesion.

– Apply sparingly to avoid staining.

To keep your model in top condition during long-term display:

– Avoid direct sunlight: PLA may deform over time when heated (> 60 °C).

– Keep dust free: Use a soft brush or compressed air to carefully remove dust.

– Do not clean with water: Moisture can damage paint or adhesive layers.

– When moving: Always lift the model by the sturdy parts; avoid pressure on thin or delicate parts.

For long-term presentation, we recommend a closed display case to limit dust and temperature fluctuations.